How do I stop my pilot light going out?
Pilot Light Instruction Guide:
- Turn off furnace, boiler, or water heater at thermostat or power switch.
- Locate the gas valve and turn knob from on or off (depending where it was) to pilot position.
- Hold down red button, which sends gas to the pilot burner.
- At the same time hold match to pilot burner.
Why does the pilot light keep going out on your boiler?
Your pilot light may be going out because it is simply dirty and filled with soot. Soot usually collects on the thermocouple. To restore the dirty thermocouple and pilot, take out a rag and a little warm soapy water and give it a good clean. You can use Q-tips to get around the little edges and corners.
Should I turn off my pilot light?
We recommend that you turn off your gas fireplace pilot light seasonally. Turning off your gas fireplace’s pilot light can save a substantial amount of energy and money. It is important to remember that not all gas fireplaces have “standing” pilot light, or, a pilot light that is “always on”.
Why does my water pilot keep going out?
Therefore, a dirty thermocouple might be the reason why your water pilot keeps going out. A layer of dirt and grime can hinder the electric current from reaching the thermocouple. As a result, the gas supply will be cut off and the pilot light will go out.
What happens if the pilot light is not lit?
Once the thermocouple detects that the pilot light isn’t lit, it turns the gas off as a safety measure. An unlit pilot can also stem from a dirty thermocouple as the dirt may be obstructing the current signal, which would also lead to a gas outage.
Why does the boiler pilot light keep going out?
Below is a list of reasons why this may be happening to your boiler. 1. Pilot Is Dirty Your pilot light may be going out because it is simply dirty and filled with soot. Soot usually collects on the thermocouple. To restore the dirty thermocouple and pilot, take out a rag and a little warm soapy water and give it a good clean.
What does it mean when your fireplace shuts off and pilot goes out?
When your gas fireplace shuts off and pilot goes out, usually it means that the thermocouple is bad or on the way of being bad. Table of Contents. The thermocouple is a component of a gas furnace. This component usually is located not far from the pilot light burner.
What should I do if the pilot light goes out?
Simply replace the cover plate, turn the control knob to “On,” and select the desired temperature on the water temperature knob so that you can return to a refreshing hot shower. If the pilot light flickers and goes out soon after relighting, clean the pilot orifice . A dirty pilot light orifice hinders gas flow, but the fix is simple.
Why does your pilot light keep blowing out?
A draft might be the reason your pilot light keeps going out. The draft can come from under a doorway, through a window or even from under the floor. An easy way to check for drafts is to place a burning candle at the approximate location of the pilot. Watch the flame, and it will alert you to a blowing wind by bending with the wind’s direction.
Is it dangerous if the pilot light goes out?
If the pilot light is not lit, the gas burner will not ignite, which could cause a dangerous situation by letting highly flammable gas escape into the air. If the pilot light goes out, you can relight it after the gas is shut off using a match or the unit’s electronic ignitor if it has one, following the proper safety precautions.
Why does my furnace pilot light keep going out?
If your furnace pilot light keeps going out, it’s likely you have a broken thermocouple in your gas furnace. The thermocouple is a rod that comes into physical contact with the flame in your system. This component will deactivates the gas when the pilot light goes out.
